Summary:When a company newly purchases air compressor equipment, it must be commissioned after installation. Why is this? Although each Rotary screw air compr...
When a company newly purchases
air compressor equipment, it must be commissioned after installation. Why is this? Although each
Rotary screw air compressor will be tested for many times before being exported by
Air compressor manufacturers, and it will also undergo strict inspection before shipment, but it cannot be completely guaranteed that it will not be damaged during transportation. Therefore, it is necessary to do the commissioning of the Rotary screw air compressor.
Check the appearance, structure, parts, etc. of the Air compressors for damage, and check the oil level of the oil and gas barrels, neither too much nor too little. In addition, in the first few hours of operation, pay attention to observe the operation of the unit. Check whether the bolts, pipes, joints, etc. of the Air compressors are connected well, and whether there is any looseness, and then debug after re-reinforcing.
If the screw air compressor is connected to a power supply for the first time, the rotation of the drive motor should be checked. Open the door, check the steering, if the steering is wrong, press the emergency stop button immediately to stop the unit. Otherwise the compressor may be severely damaged.
When commissioning, make sure that no one is left in the danger zone next to the motor or compressor. When running the screw air compressor, the door and panel must be closed and safety measures must be taken. Due to the last operation, the safety valve may still be in a hot state, and the kinetic energy inspection must be carried out under the working pressure. Be careful of leaking air to prevent accidents.
PRODUCT FEATURES
UItra-low frequency speed control technology far surpasses standard VSD compressor systems.Capable of lower than 15Hz operation，this system is truly capable of constant variable pressure operation and significant energy saving.
USoft-start feature allows for little or no impact on the power supply system and marginalises mechanical wear and tear up on start-up.
English
简体中文
русский
España
Português
Français
